Simple DIY chicken feeders built with hand tools and clean food-safe containers, and the extension rules on height, lip and grill that keep feed in.
- Maryland Extension: a homemade feeder needs a grill against roosting and scratching, and a lip against spills.
- Set the feeder's lip at the hens' back height, say Penn State, Oregon State and Maryland Extension.
- Penn State: fill a trough only one-third to one-half full to prevent feed wastage.
In this guide

A DIY chicken feeder can be as simple as a wooden trough or a lidded bucket over a pan. The University of Maryland Extension puts the design first: it says a feeder “can be built from scrap lumber, but it is critical that it be designed to avoid feed waste.” That means a grill or other device so hens can’t roost or scratch in it, a lip so feed doesn’t spill out, and the right height, which is the back height of the chickens.
The four rules every homemade feeder should follow
These come straight from extension guidance.
- A grill or guard on top. Maryland Extension: the feeder “must have a grill or other device to keep chickens from roosting on it or scratching in it.”
- A lip. The same source calls for “a lip to keep the feed from being spilled out.”
- Back height. Penn State Extension says the lip should be level with the birds’ back height. Oregon State University Extension says this “reduces spillage (which discourages rodents).” If bantams and large hens share a feeder, Oregon State says to set it for the bantams.
- Enough room. Penn State recommends 3 inches of feeder space per bird. Maryland says 2–3 inches per laying hen. Oregon State says at least 4 linear inches for adults, and enough space “so that all the birds can eat at the same time.”
One more from Penn State: fill a trough feeder “only one-third to one-half full to prevent feed wastage.” The UNH Extension says the same in plain terms: don’t overfill to the point where feed spills onto the floor.
Materials: food-safe and clean
Use a clean container that held food, or one sold as food-grade, not one that held chemicals. Wash and dry it before feed goes in. Feed should stay dry. Oregon State says to keep stored feed in a cool, dry place and warns that “some molds that grow in damp feeds are dangerous for chickens.”
The UNH Extension notes that plastic feeders “are also excellent options and are easy to sanitize,” and that a round metal hanging feeder or a metal trough also works well.
All the ideas below use hand tools only: a hand saw, hammer, screwdriver, tin snips and a utility knife. Follow the safety instructions that come with each tool, and check that no sharp cut edges are left where hens feed.
Idea 1: Wooden trough with a grill (adult hens)
This build follows the requirements Maryland Extension lists.
- Box: cut clean scrap boards with a hand saw into a long, narrow trough with closed ends. Nail or screw it together.
- Lip: let the top edges turn slightly inward, or fasten a thin strip along each top edge so feed can’t be flicked out.
- Grill: across the top, fit a wire grill or a row of spaced wooden slats. Hens put their heads through, but they can’t stand in the feed.
- Length: use the space rules above. For 6 hens at Penn State’s 3 inches each, you need about 18 inches of feeding edge (Maryland’s 2–3 inches gives 12–18 inches; Oregon State’s 4 inches gives at least 24). If hens can reach both long sides, count both sides.
- Height: set it on blocks or bricks so the lip is at the hens’ back height, then raise it as young birds grow.
Idea 2: Lidded bucket over a pan (gravity)
A lidded food-grade bucket holds the feed. With a utility knife, cut a few small openings near the bottom edge so feed trickles into a shallow pan underneath. Keep the openings small so the pan fills slowly and doesn’t overflow. Set the bucket in the pan on blocks so the pan’s lip sits at back height. (To hang it instead, the pan has to be fixed to the bucket.) The lid keeps rain and droppings out of the stored feed.
This is the same idea as a hanging tube feeder. Maryland Extension says store-bought hanging tube feeders are adjustable and can be used from one week of age through adulthood; it doesn’t say this about homemade versions.
Idea 3: Chick feeders from egg flats or a low box
For the first days, Maryland Extension says “homemade boxes, egg flats and similar low, open designs are acceptable as long as the chicks have easy access to the feed, and feed waste is controlled.” It also says to move chicks gradually to tube or trough feeders so open feeders can be removed when the chicks are 10 days old. For the rest of the brooder setup, see how to set up a chick brooder.
How big to build it
Mississippi State University Extension says an average laying hen eats about 1/4 to 1/3 pound of feed per day, depending on weather, size and laying. For 6 hens, that’s about 1.5 to 2 pounds a day (our arithmetic). A feeder holding about 10 pounds would last roughly 5 to 7 days for them.
Remember Penn State’s one-third to one-half fill rule for open troughs. A trough needs refilling more often than its full volume suggests. To work out monthly feed and cost for your flock, use the feed and egg cost calculator.
Storing the rest of the feed
Oregon State recommends storing feed “for a maximum of two months,” in enclosed solid containers such as a covered trash can, to reduce its availability to rodents. The UNH Extension also says to use rodent-proof containers in a cool, dry place. A metal can with a tight lid next to the coop is one way to follow both.
Bottom line
A homemade feeder works if it follows the extension basics: a grill against roosting and scratching, a lip against spills, the lip at back height, and enough edge for every hen. Build it from clean, food-safe materials with hand tools, and fill open troughs only one-third to one-half full. For store-made treadle, gravity and covered-port models, see our chicken feeder guide.
Sources (5)
- University of Maryland Extension — Housing Requirements (checked 2026-11-11)
- Penn State Extension — Management Requirements for Laying Flocks (checked 2026-11-11)
- Oregon State University Extension — PNW 477, How to Feed Your Laying Hens (checked 2026-11-11)
- University of New Hampshire Extension — Producing Your Own Eggs (checked 2026-11-11)
- Mississippi State University Extension — Feeds and Nutrition (checked 2026-11-11)