The Coop Almanac

Chicken Brooder Box Setup: Space, Heat, Bedding and Water

How to set up a chicken brooder box: space per chick, heat at chick level, bedding, feed and water, based on Penn State and UNH Extension guidance.

At a glance
  • Penn State Extension: about 1/4 sq ft per chick in week 1, rising to 1 sq ft by weeks 5–8.
  • Penn State says 95°F at chick level under the heat in week 1, then 5°F lower each week.
  • Heat lamps at least 20 inches from anything flammable (Penn State); plates have their own limits.
$
We may earn a commission if you buy through links on this page; it doesn't change what we list or how we describe it. Learn more.
▲
Fire safety. Heat lamps and heaters can start fires. Follow the manufacturer's instructions exactly, secure every fixture so it can't fall, and keep it away from bedding.
In this guide
  1. 1. The box: size and space per chick
  2. 2. The heat source
  3. 3. Bedding
  4. 4. Feed and water
  5. 5. Before the chicks arrive
  6. Fire safety
  7. Bottom line
Illustration of a chick brooder box with a heat plate at one end, bedding, a chick feeder and a waterer

A chicken brooder box needs four things: enough floor space (Penn State Extension lists about 1/4 square foot per chick in the first week), a secured heat source that gives about 95°F at chick level, dry bedding that isn’t slippery, and feed and water the chicks can reach without falling in. Set it all up and let it warm before the chicks arrive — Penn State Extension says to prepare the brooding area 48 hours ahead.

Below is each part, with who says what. We don’t test brooders; everything here comes from extension guidance and makers’ published specs.

1. The box: size and space per chick

Whatever box you use, it needs the space below and no drafts. Penn State Extension says the brooding area should have no drafts and suggests a chick guard for the first few weeks “to prevent drafts” and keep chicks near the heat. The University of New Hampshire (UNH) Extension describes a brooder guard as a cardboard or wire mesh ring around the heat source and says it can come out after one week.

Penn State Extension’s summary table gives floor space by age:

AgeFloor space per birdFeeder space per chickWater space per chick
1st week1/4 sq ft1 in1/2 in
2–3 weeks1/2 sq ft1½ in1/2 in
3–5 weeks3/4 sq ft2 in1/2 in
5–8 weeks1 sq ft2 in3/4 in
8 weeks and up1½ sq ft3 in1 in

Penn State notes the last row should go up as birds grow and for larger breeds. So a box that fits six chicks in week 1 (about 1.5 sq ft by this table — our arithmetic) needs about 6 sq ft by weeks 5–8 — plan for a bigger box or a second space before the chicks outgrow the first one.

UNH Extension adds a layout point: leave enough room under the heat so chicks don’t crowd, and enough room away from it so they can move out of the heat.

2. The heat source

This page covers two options: a heat lamp hung over the chicks, or a heat plate the chicks stand under. We compare them in detail on heat lamp vs heat plate. For setup, what matters:

  • Temperature target. Penn State Extension: “Supply 95°F at chick level under the heat source for the first week,” then lower it by 5°F per week until the normal daily temperature (62–65°F) is reached. UNH Extension gives 90–95°F for the first week. The full schedule is on chick temperature by week.
  • Where to measure. Penn State says to measure at chick level, directly under the heat source. UNH says 2.5 inches above the litter, directly below the hood.
  • Put the heat at one end. Both extension services describe chicks moving toward or away from the heat to stay comfortable, so the box needs a warm zone and a cooler zone.
  • Heat lamps should be at least 20 inches from any flammable material, hung by a chain or cable (Penn State Extension). UNH Extension says not to hang the lamp by its cord and to use a “Hard Glass” bulb where possible.
  • Heat plates follow the maker’s rules. Brinsea, for example, says its EcoGlow Safety 600 and 1200 are for indoor use only and the room should not drop below 50°F.

Heat sources mentioned on this site, as of November 10, 2026:

ModelTypeChicks (maker)Power (maker)Price
Brinsea EcoGlow Safety 600heat plate, 12 Vup to 2012 W$89.99 (list $99.99) at My Pet Chicken; $79.99 (list $99.99) at brinsea.com
Brinsea EcoGlow Safety 1200heat plate, 12 Vup to 3518 W$124.99 (list $139.99) at My Pet Chicken; $111.99 (list $139.99) at brinsea.com
Hatching Time Warmzy 12” x 16”heat plateup to 3030 W$55.99 (list $69.99)
K&H Thermo-Poultry Brooder, Smallheat plateup to 1525 W$59.98 (list $82.99)
RentACoop 12x12” Heating Plateheat plateup to 2022 W$59.95
Red infrared heat lamp bulbbulb only, 250 W—250 W$9.99 at My Pet Chicken (fixture with clamp sold separately, $19.99)

Chick counts are the makers’ figures for newly hatched chicks; Brinsea says the EcoGlow 1200 holds 20 to 25 older chicks. Note that My Pet Chicken, which sells the red bulb, writes on its own page that it “can not recommend them for chicks or coops.”

3. Bedding

  • Penn State Extension: on a floor, start with 2–3 inches of clean, dry litter. Avoid sawdust or other fine litter for the first few weeks so chicks don’t eat too much of it. Never brood chicks on slippery surfaces like newspaper or wood floors.
  • UNH Extension: wood shavings are the most common choice; ground corn cobs, peanut and rice hulls, and chopped hay or straw also work. Don’t use shiny printed newspaper, cardboard or plastic, because the slippery surface may lead to leg damage.

4. Feed and water

  • Water. Penn State Extension: supply one quart of water for every 25 chicks, in drinkers the chicks “can reach but not fall into.” For bantams and other small fowl, it suggests marbles or pebbles in the water tray. Clean and refill waterers daily.
  • First drink. With small numbers, Penn State says it helps to dip each chick’s beak into the water briefly so it finds it. UNH Extension says the same.
  • Feed. For the first week, Penn State suggests feed in an egg carton top or a shoe box cover; place feeders near the heat but not directly under it. UNH Extension says to give enough feeder and water space for all chicks to eat and drink at once, set “like spokes of a wheel” around the brooder, and to move up to bigger feeders as chicks grow.

When the flock moves to adult gear, see chicken waterers.

5. Before the chicks arrive

  • Clean the space. Penn State Extension says a previously used brooding area should be cleaned and disinfected at least two weeks before brooding.
  • Turn on the heat and set the bedding ahead of time: Penn State Extension says 48 hours before the chicks arrive, so floor and materials warm up; UNH Extension says to set up and test the brooder at least one day before.
  • Check the temperature at chick level with a thermometer. Penn State recommends a high/low thermometer for times you can’t watch the brooder.
  • Watch the chicks after they go in. Penn State Extension: comfortable chicks spread evenly; cold chicks huddle under the heat; chicks that are too warm move as far from it as they can.

If chicks seem weak, chilled or unwell, talk to a poultry veterinarian or your county extension office.

Fire safety

Follow your heat source maker’s instructions first. On top of that:

  • Penn State Extension: keep heat lamps at least 20 inches from any flammable material; secure every heat source so it can’t move or slip toward flammable material; use a chain or cable to hang heating equipment.
  • UNH Extension: don’t hang a lamp by its cord; use a hard-glass bulb where possible; make sure the lamp doesn’t get close enough to catch the bedding on fire.
  • NFPA (National Fire Protection Association) tips, as published by the Clark County (WA) Fire Marshal’s office: relying on the spring clamp alone is not adequate to keep a lamp from falling; brush dust and cobwebs from fixtures and outlets regularly; choose equipment made for agricultural or commercial use; don’t use extension cords in coops.

Bottom line

Size the box by Penn State Extension’s space table and plan to expand when its space figure doubles at 2–3 weeks; heat one end to about 95°F at chick level, measured where the chicks stand; use 2–3 inches of dry, non-slippery bedding; and give shallow water and low feeders near (not under) the heat. Whatever heat source you choose, its maker’s manual and the fire-safety points above come first.

+
If a bird seems sick or injured, contact a veterinarian who treats poultry, or your state's animal health office or county extension office.
Sources (12)
  1. Penn State Extension — Brooding of Domestic Fowl (checked 2026-11-11)
  2. University of New Hampshire Extension — Brooding and Caring for Chicks (checked 2026-11-11)
  3. Clark County (WA) Fire Marshal — Safety tips to prevent a chicken coop fire, May 6, 2021 (checked 2026-11-11)
  4. Brinsea — EcoGlow Safety 600 product page (checked 2026-11-11)
  5. Brinsea — EcoGlow Safety 1200 product page (checked 2026-11-11)
  6. Hatching Time — Warmzy Heating Plate 12 x 16 (maker and store, checked 2026-11-11)
  7. K&H Pet Products — Thermo-Poultry Brooder (maker and store, checked 2026-11-11)
  8. RentACoop — 12x12 Adjustable Heating Plate (maker and store, checked 2026-11-11)
  9. My Pet Chicken — Infrared Heat Lamp Bulb, Red, 250 W (store, price as of 2026-11-10)
  10. My Pet Chicken — EcoGlow Safety 600 (store, price as of 2026-11-10)
  11. My Pet Chicken — EcoGlow Safety 1200 (store, price as of 2026-11-10)
  12. My Pet Chicken — Brooder Lamp w/clamp (store, price as of 2026-11-10)

More on brooder

All →